Genicom GEK 00031B Programmer's Manual page 211

DAR
GEK-00029B
Printer Attributes Report (generic response): Response to a Print
manager request for a Printer Attributes (DA) report.
Source: Printer
Format
CSI ? Ps1 Ps2 ... Psn c
Description
The printer sends this command when set to the generic response.
The printer may be set to use the alias response. See DAR (alias
response) in this chapter.
Ps1 = 73
Ps2-Psn describe the implemented extensions to the protocol. See the
introduction to this chapter for an explanation of extensions. The
following table contains a list of possible extensions.
Parameter
Hex Decimal
34
35
36
38
39
31 30
31 31
31 32
The reply to the DA request is sent to the host only after all preceding
data (except DSR) has been processed and printed. This provides a
way for host software to determine when all preceding data has been
successfully printed.
When values are not returned, they are left out of the response
entirely (that is, there are not any blanks indicated by semicolons).
However, software should always accept blank parameters.
The printer sends parameters in ascending order. However, software
should accept the parameters in any order.
Destination: Print manager
Protocol Extension
4 Sixel graphics
5 Katakana character set
6 Reserved
8 Reserved
9 Variable page format select
10 Text ruling vector drawing
11 Reserved
12 Hebrew character sets
211
5000 Series Programmer's Manual