Genicom GEK 00031B Programmer's Manual page 144

ESC ! n
ESC k n
ESC x n
Chapter 6. Epson FX286-E Emulation
Master Print Mode Select: Selects any valid combination of the
printing modes listed below. The parameter n is equal to the sum of
the decimal values associated with each mode. Note that pica and
elite are mutually exclusive and proportional overrides condensed.
Also, pica and elite proportional are the same. (See "Print Mode
Combinations," page 7-2.)
n
0
1
2
4
8
16
32
64
128
Decimal: 27 33
Hex: 1B 21
BASIC: CHR$(27);"1";CHR$(n);
Select Font Style: Selects the Roman (Courier) typeface if n is 0 and
Sans Serif (Gothic) if n is 1. This command will not activate the
selection. but sets the style to be activated by the ESC x (n) sequence.
Refer to the "Functional Differences" section on page 7-4 for a
description of typefaces used.
Decimal: 27 107
Hex: 1B 6B
BASIC: CHR$(27);"k";CHR$(n);
Select NLQ or Draft Printing: Selects NLQ or draft printing. When
selecting NLQ, the style will be the one that was last selected by the
ESC k (n) sequence.
n=1 NLQ
n=0 draft
Decimal: 27 120
Hex: 1B 78 -
BASIC: CHR$(27);"x";CHR$(n);
Effect
Pica
Elite
Proportional
Condensed
Emphasized
Double-Strike
Double-Width
Italic
Underline
144
GEK-00029A