Genicom GEK 00031B Programmer's Manual page 236

LNM
LS*/LS*R/SS*
Chapter 8. PPL3 Plus Emulation
Line Feed/New Line Mode: Instructs the printer to move to the Line
Home Position on the next line upon receipt of a Line Feed (LF).
Source: Print manager
Format
CSI 2 0 h
CSI 2 0 1
Description
If LNM is set and a Line Feed is received, the active position advances
to the Line Home Position of the next line. If LNM is reset and a Line
Feed is received, the active position advances to the same horizontal
position on the next line.
Locking and Single Shifts: These sequences invoke the GO-G3
character sets into GL or GR.
Source: Application Destination: Levels 1, 2, 3
Format
Name Mnemonic
Single Shift 2 SS2
Single Shift 3 SS3
Shift Out SO
Shift In SI
Locking Shift 0 LS0
Locking Shift 1 LS1
Locking Shift 2 LS2
Locking Shift 3 LS3
Locking Shift 1 LS1R
Right
Locking Shift 2 LS2R
Right
Locking Shift 3 LS3R
Right
There is no LS0R.
Description
See page 198 for more information on designating and invoking
character sets.
The effect of a single shift (SS2 or SS3) continues only for the first
printable GL character that follows the single shift sequence.
The effect of a locking shift (LS2, LS3, LS1R, LS2R, or LS3R)
continues indefinitely; that is, until another locking shift changes the
effect, or until reset or power down.
Destination: Levels 2, 3
LF acts as New Line
LF acts as Line Feed
Sequence
ESC N (1B 4E)
ESC O (1B 4F)
SO (0E)
SI (0F)
SI (0F)
SO (0E)
ESC n (1B 6E)
ESC o (1B 6F)
ESC ~ (1B 7E)
ESC } (1B 7D)
ESC | (1B 7C)
236
Function
The character that follows
the SS2 is selected from G2.
The character that follows
SS3 is selected from G3.
See Locking Shift 1.
See Locking Shift 0.
G0 becomes the active GL
character set.
G1 becomes the active GL
character set.
G2 becomes the active GL
character set.
G3 becomes the active GL
character set.
G1 becomes the active GR
character set.
G2 becomes the active GR
character set.
G3 becomes the active GR
character set.
GEK-00029B