Genicom GEK 00031B Programmer's Manual page 15

FF
HT
LF
SI
SO
VT
GEK-00029B
Form Feed (0CH): Line terminator. The paper is advanced to the
top-of-form position. When the EVFU is enabled and programmed, paper
will advance to the next stop in channel 1.
An option strap from the CCU Control Panel Menu using the
SETUP/FORMAT/MODIFY FORMAT/GENPRTOPTS selection
can disable this feature.
Horizontal Tab (09H): Advances the print position to the next
horizontal tab location. If no tabs are set, an HT code is either converted to a
space or ignored, depending on the menu option settings.
Line Feed (0AH): Line terminator. The paper is advanced to the
line. When printing horizontal dot graphics, the paper is advanced to the next
dot row.
(See note for <FF>, above.)
Shift In (0FH): Used to exit a Special Print Mode (GENSPM) when
ANSI emulation strap 1 (Appendix G, tables 5 and 6) is active.
Shift Out (0EH): Used to enable a special print mode (GENSPM)
ANSI emulation strap (Appendix G, tables 5 and 6) 1 is inactive.
Vertical Tab (0BH): Line terminator. The paper is advanced to
next vertical tab stop. If no tabs are set, a VT code causes a line feed. When
using the EVFU, paper advances to the next stop in channel 12.
(See note for <FF>, above.)
NOTE
15
next
next
when
the
5000 Series Programmer's Manual