General Printer Options Definitions - Genicom GEK 00031B Programmer's Manual

GENERAL PRINTER OPTIONS DEFINITIONS

H Bits
Function
01-32
01 Prime
02 Interrupt
03 DEL
04 DEL
05-06 Reserved.
07 Underline character
08 PI Lead
09 ACK lead
Character
10
conversion to space.
11 CR
12 FF
13 LF
14 VT
15 DC3
16 DC1
17 Busy
Busy/Demand per
18
character.
Software control of
19
Busy.
20 Busy
21 Busy
22 Busy
23 ACK
24 ACK
25 Data leads
26 Busy is active
27 PI is active
28 PI
29 STB is active
30 SELECT is active
31 PO is active
32 FAULT is active
H Bits
Function
33-64
33
Demand delay.
Set ACK delay from
34-35
Strobe.
Set ACK Pulse
36-37
Width.
38-40
Reserved.
Used with strap 10 to select space character substitution. 41 corresponds with Bit 1 of the
41-48
character code.
49-64
Reserved.
GEK-00029B
I/F Hardware Straps
If Enabled
High = Buffer Clear.
On all Control Codes.
Does not cause an Interrupt.
Does not cause Prime.
Treated as CR.
Causes Interrupt.
Does not reflect
ONLINE/LOCAL status. 05
must be enabled.
Enabled. (See 41-48.)
Not decoded.
Not decoded.
Not decoded.
Not decoded.
Not decoded.
Not decoded.
Does not reflect ACK.
Enabled.
Disabled
Does not reflect
(ONLINE/LOCAL) FAULT/PO
status.
Does not reflect (FAULT)
ONLINE/LOCAL status.
Does not reflect (PO)
ONLINE/LOCAL/PO status.
Does not reflect PO.
Does not reflect FAULT.
0-7 are active high.
High.
High.
Enabled.
High.
High.
High.
High.
If Enabled.
Disabled.
269
If Disabled
Low = Buffer Clear.
Disabled on all Control Codes, except
LF, VT, FF, CR, DC1 and DC3.
Causes an Interrupt.
Causes Prime.
Printed.
Does not cause Interrupt.
Reflects ONLINE/LOCAL status.
Disabled.
Generate an Interrupt.
Generate an Interrupt.
Generate an Interrupt.
Generate an Interrupt.
Generate an Interrupt.
Generate an Interrupt.
Reflects ACK.
Disabled.
Enabled.
Reflects (ONLINE/LOCAL) FAULT/PO
status.
Reflects (FAULT) ONLINE/LOCAL
status.
Reflects (PO) ONLINE/LOCAL/PO
status.
Reflects PO.
Reflects FAULT.
0-7 are active low.
Low.
Low.
Disabled.
Low.
Low.
Low.
Low.
If Disabled
Enabled.
34 35 Delay
Disable Disable None
Disable Enable 1 µsec
Enable Disable 2 µsec
Enable Enable 3 µsec
36 37 Width
Disable Disable None
Disable Enable 1 µsec
Enable Disable 2 µsec
Enable Enable 3 µsec
5000 Series Programmer's Manual