Control
Function
Type
Partial Line
Special
Up
Reverse
Relative
Index
Vertical
Absolute
Position
Absolute
Vertical
Relative
Position
Backward
Vertical
Relative
Position
Relative
Vertical Tab
Absolute
GEK-00029B
Margin effect
Can go up to one PLU
position above top margin
Can go up to top margin
Maximum vertical movement
possible is up to bottom
margin. Resulting vertical
position more than bottom
margin will set the active
vertical position to bottom
margin
Can go up to top margin.
Performs the FF if resulting
vertical position is below
bottom margin.
If there is no tabs in the tab
table or no valid tab between
the current position and BM
then VT brings the cursor to
bottom margin (BM).
Bounds
▪
Page Home Line is same as Top Margin Line
▪
Page End Line is same as Bottom Margin Line
▪
Line Home Position is same as Left Margin Position
▪
Line End Position is same as Right Margin Position
Parameter Used
All
Increments the PLU/PLD count
(Maximum
PLU/PLD count
value is 255)
All
Clears PLU/PLD count and
Superscript/Subscript count.
Resulting vertical position
above top margin Sets FCF.
All
Clears PLU/PLD count and
Superscript/ Subscript count..
In RESET mode command sets
the FCF flag.
All
Clears PLU/PLD count and
Superscript/Subscript count.
Sets the FCF if the resulting
vertical position is above top
margin.
All
Clears PLU/PLD count and
Superscript/Subscript count.
In RESET mode command sets
the FCF flag.
All
Clears PLU/PLD count and
Superscript/Subscript count.
Sets the FCF
255
Flags
5000 Series Programmer's Manual