Genicom GEK 00031B Programmer's Manual page 21

CSI p1 p2 SP ~
GEK-00029B
GENEMU (Emulation Control): Switches the control of the printer to
another emulation. The parameters in the sequence are defined as
follows:
p1 Emulation identifier. This parameter selects the particular
emulation by a reference number supplied by GENICOM
engineering. The assigned numbers may be found in the table
below.
p2 Reset control. Permits the parameters of the printer to be
reset or defaulted. It is not always possible to meet the strict
definition of this parameter, so each printer has a definition of
how the reset control is implemented. The values as currently
defined are:
0 Hold values (default). All possible values for printer
control, e.g., tabs, margins, page length, are to be
retained.
1 Full reset. Resets parameters to initial state.
p1 Manufacturer
0 GENICOM
10 GENICOM
1-19 GENICOM
20 IBM
21 IBM
22 Epson
23 IBM
24 Epson
30 Data Products
40 Printronix
41 Printronix
Indeterminate Conditions
If no emulation parameter is supplied, the emulation remains in the
current state and the rest of the sequence is ignored. Other
parameter values and other parameters are reserved.
Mnemonic: <CSI> <p1> <p2> <SP> ~
Decimal: 27 91 <p1> <p2> 32 126
Hex: 1B 5B <p1> <p2> 20 7E
BASIC: CHR$(27);"<p1><p2><SP>~";
Emulation
ANSI
4410 ANSI
Reserved
Graphics Printer
Proprinter XL 9-wire
FX286-e
Proprinter XL 24-wire
LQ2500
ANSI
P300
P5008
21
5000 Series Programmer's Manual