Memory Programming - Icom IC-28H Instruction Manual

ein the VFO mode, turn clockwise to increase the operating fre-
quency and counterclockwise to decrease it.
After pushing the
SET SWITCH, the TUNING CONTROL is used to select the
subaudible tone number on the 1С-28Н (U.S.A. version), to set the
amount of transmit offset when using the duplex mode and to
select the tuning step size for frequency changes with the TUNING
:
CONTROL.
Refer to SECTIONS
5-4 SUBAUDIBLE
TONE
ENCODER and DUPLEX PROGRAMMING, and 5 - 1 RECEIV-
ING.
DOWN UP
In the VFO mode, push to change the selected operating frequency
in 1MHz
increments.
In the MEMORY
mode, push to change the
selected memory channel in one channel increments. Refer to
e TONE SWITCH:
Push to turn ON and OFF the subaudible tone encoder when using
the duplex mode. The word "ТОМЕ" appears when the tone
encoder is turned ON. Refer to SECTION 5-4 SUBAUDIBLE
TONE ENCODER.
CALL SWITCH [CALL] eCALL SWITCH:
CALL
E
• |п the VFO mode, push to store the displayed frequency on the
LCD
readout in the memory channel represented by the memory
channel
number also
displayed. Refer
to SECTION
5-2
MEMORY PROGRAMMING.