Application Parameters (B) - Omron SYSDRIVE 3G3FV User Manual

Advanced Operation
Group Group Function Function
Terminal e a H1 Digital Inputs
H2 Digital Outputs
H3 Analog Inputs
H4 Analog Outputs
H5 Serial Com Setup
Protection o ec o
L1 Motor Overload
L2 PwrLoss Ridethru
L3 Stall Prevention
L4 Ref Detection
L5 Fault Restart
L6 Torque Detection
L7 Torque Limit
L8 Hdwe Protection
O e a o Operator
o1 Monitor Select
o2 Key Selections

6-5-2 Application Parameters (b)

H Setting Operation Source Selection (b1)
The input methods of parameters or frequency references and the operation methods of the run com-
mand can be set in the Inverter in operation mode. In addition, the following advanced functions are
available.
The run command already set in the Inverter can be disabled or enabled when switching the Inverter to
local mode from remote mode.
The run command already set in the Inverter in any mode other than drive mode can be disabled or
enabled.
Set the parameter according to the application.
Parameter Display name p y
number
b1-07 LOC/REM RUN
Set
Explanation of Settings
Setting
0 The run command already set is disabled (when the Inverter is switched to local mode
from remote mode. The Inverter will start operating with the run command input again.)
1 The run command already set is enabled (and the Inverter will start operating according
to the present run command when the Inverter is switched to local mode from remote
mode).
Note If parameter b1-07 (LOC/REM RUN Sel) is set to 1, the run command will not be ignored. In this
case, an Inverter may start operating immediately when switched to remote mode from local
mode. Take necessary measures for safety.
Comments Comments
S Function selection for multi-function inputs
S Function selection for multi-function outputs
S Adjustment/function selection for external analog in-
puts
S Adjustment/function selection for multi-function analog
outputs
Not Used. (Do not change this setting.)
S Sets electrical/thermal functions that protect the motor.
S Selects the power-loss processing method.
S Accel/Decel stall prevention settings and selection
S Frequency detection settings and selection
S Fault restart function settings
S Sets overtorque detection functions 1 and 2
Torque limit settings
S Hardware overheating and phase loss protection set-
tings
S Selects the Operator's display and setting methods.
S Operator's key function selection and other parame-
ters
Setting g Units Default
range setting
0, 1 --- 0
OK
OK
OK
OK
---
OK
OK
OK
OK
OK
OK
---
OK
OK
OK
Valid access levels
V/f V/f with
Control PG
Advanced
Description
Chapter 6
Control mode
V/f V/f Open-loop Flux
w/PG Vector Vector
OK OK OK
OK OK OK
OK OK OK
OK OK OK
--- --- ---
OK OK OK
OK OK OK
OK OK OK
OK OK OK
OK OK OK
OK OK OK
--- OK OK
OK OK OK
OK OK OK
OK OK OK
Open Loop Flux
Vector Vector
6-41