Motor Constant Parameter Lists - Omron SYSDRIVE 3G3FV User Manual

Parameter Lists
Para Para Name
meter meter
Display
No. No.
name
d5-03 Sets the speed limit command
Speed limit
selection method for the torque control
mode.
1: The analog input limit from
an analog frequency an analog frequency
Speed Limit
reference terminal
Sel
(terminals 13 and 14.)
2: Limited to d5-04 parameter
setting values.
d5-04 Speed limit Sets the speed limit during
torque control as a percentage
of the maximum frequency.
Note: This function is enabled
Speed Lmt
Value
d5-05 Sets the speed limit bias as a
Speed limit
bias percentage of the maximum
frequency.
Note: Bias is given to the speci Note: Bias is given to the speci-
Speed Lmt
Bias
d5-06 Speed/ Sets the delay time from
inputting the multi-function input
torque con-
"speed/torque control change"
trol switch-
ing timer. (from ON to OFF or OFF to ON)
until the control is actually
changed, in ms units.
Note: This function is enabled
Ref Hold
Time

7-2-4 Motor Constant Parameter Lists

H V/f Pattern: E1
Name
Para
meter meter
Display
No.
name
E1-01 Sets the Inverter input voltage in
Input
voltage units of 1 V.
setting
Note: This setting is used as the
Input
Voltage
7-24
Description Description
1, 2
–120 to
+120
when d5-03 is set to 2. when d5 03 is set to 2
Directions are as follows.
+: operation command
direction
–: operation command
opposite direction
0 to
120
fied speed limit. It can be
used to adjust the margin
for the speed limit.
0 to
1000
when the multi-function
input "speed/torque con-
trol change" is set. In the g
speed/torque control speed/torque control
switching timer, the three
analog inputs hold the
values of when the
"speed/torque control
change" changes. Always
be sure to allow time for
this process to finish com-
pletely.
Description
155 to
255
(see
note 1) note 1)
reference value for func reference value for func-
tions such as the protec-
tion functions.
Setting Setting Default Default Chan- Chan-
range range setting setting ges ges
during during
opera- opera-
tion tion
1 NO
0 NO
10 NO
0 NO
Setting Default Chan-
range range setting setting ges ges
during
opera-
tion
200 NO
(see
note 1)
Chapter 7
Control mode
V/f V/f Open
control with loop
PG vector
X X X
X X X
X X X
X X X
Control mode
V/f V/f Open
control with loop
PG vector
Q Q Q
Page Page
Flux
vector
A 6-22
A 6-23
A 6-24
A 6-28
Page
Flux
vector
Q 5-20,
5-23,
5-35,
5-44 5-44