Omron SYSDRIVE 3G3FV User Manual page 245

Advanced Operation
Installation Procedure
1. Turn off the Inverter's main-circuit power supply. Wait at least one minute (or at least three minutes
for models of 30 kW or more), and then remove the Inverter's front cover. Check to be sure that the
CHARGE light is turned OFF.
2. Check the Optional Card's installation location (A, C, or D).
Type of card
Analog Reference g
Card C d
Digital Reference g
Card C d
PG Speed Control
Card C d
Analog Monitor Card g
Pulse Monitor Card
3. Insert the accessory spacer into the spacer mounting hole in the Inverter's mounting base.
4. Align the Optional Card connector with the connector position on the control board, and then pass
the spacer through the spacer mounting hole on the card. Press firmly until the spacer snaps into
place.
5. Connect the Optional Card's FG connection line to the Inverter's FG terminal (terminal 12).
4CN
Option A connector
2CN
Option C connector
3CN
Option D connector
H Setting a Analog Reference Card (F2)
When using a 3G3IV-PAI14B/PA114U Analog Reference Card, set parameter b1-01 (reference selec-
tion) to "3" (option).
When using a 3G3IV-PAI14B, set the function for channels 1 to 3 with parameter F2-01. (There are no
parameters to set for 3G3IV-PAI14U.)
Model
3G3IV-PAI14U
3G3IV-PAI14B
3G3IV-PDI08
3G3IV-PDI16H2
3G3FV-PPGA2
3G3FV-PPGB2
3G3FV-PPGD2
3G3FV-PPGX2
3G3IV-PAO08
3G3IV-PAO12
3G3IV-PPO36F
Option A
Front View
Specifications
14-bit analog, 2 inputs (voltage/current)
14-bits analog, 3 inputs
8-bit digital input (BCD/binary)
16-bit digital input (BCD/binary)
Open-collector-compatible, single input
Open-collector-compatible, A/B-phase input
Line-driver-compatible, single input
Line-driver-compatible, A/B-phase input
8-bit analog output, 2 channels
12-bit analog output, 2 channels
Pulse frequency output
Control board
Option C
Option D
Chapter 6
C
C
C
C
A
A
A
A
D
D
D
Inverter's mounting base
Side View
Location
6-71