Omron SYSDRIVE 3G3FV User Manual page 97

Preparing for Operation
Parameter Display name p y
number
o1-02 Power-On
Monitor
The following example shows how to change parameter o1-02 so that the output current is displayed at
startup. (The procedure continues from the end of the previous example.)
Key sequence
2 times
Note In this example, the setting is changed in the Basic access level.
Setting g Units Default
range setting
1 to 4 --- 1
Display
Monitor Select display (See the previous example.)
Displays the Power-On Monitor display.
Displays the parameter setting for o1-02.
Sets the parameter to output current.
Writes the new setting.
Returns to the Power-On Monitor display.
Returns to the function selection o1 display.
Returns to the program mode display.
Valid access levels
V/f V/f with Open Loop
Control PG
Basic or Advanced
Explanation
Chapter 3
Flux
Vector Vector
3-17