Mounting The Digital Operator - Omron SYSDRIVE 3G3FV User Manual

Installation
Mounting the Front Cover
Mount the front cover to the Inverter by taking in reverse order to the steps to remove the front cover
after wiring the terminals.
Do not mount the front cover with the Digital Operator attached to the front cover, otherwise Digital
Operator may malfunction due to imperfect contact.
Insert the tab of the upper part of the front cover into the groove of the Inverter and press the lower part
of the front cover onto the Inverter until the front cover snaps shut.
H Mounting the Digital Operator
Hook the Digital Operator on clicks A of the front cover in the arrow 1 direction as shown in the follow-
ing illustration.
Press the Digital Operator in the arrow 2 direction until it snaps shut with clicks B.
Note Do not remove or attach the Digital Operator or mount or remove the front cover using methods
other than those mentioned above, otherwise the Inverter may malfunction due to imperfect con-
tact or break.
H Removing the Front Cover of Inverters with 18.5-kW Output or More
The front cover can be removed without removing the Digital Operator from the Inverter provided that
the Inverter model is one with an output of 18.5 kW or more.
Loosen the four screws of the front cover and move the front cover slightly upwards to remove the front
cover.
Chapter 2
Clicks A
Clicks B
2-13