Digital Operator - Omron SYSDRIVE 3G3FV User Manual

Introduction
H Digital Operator
Key Name
Operation Mode
Selection Key
Menu Key
Escape Key
Jog Key
Forward/Reverse
Rotation Selection Key
Reset/Digit Selection
Key
Increment Key
Decrement Key
Enter Key
Run Key
Stop Key
Note For safety reasons, the reset operation will not function when a forward or reverse run command
is being input. Use the reset after turning OFF the run command.
1-10
Operation Mode Indicators
DRIVE:
FWD:
REV:
SEQ:
REF:
Two-line LCD that displays data for monitoring,
parameter names, and set values with 16 charac-
ters per line.
Execute operations such as setting parameters,
monitoring, JOG, and auto-tuning.
Switches between Operator and parameter setting (run command and
frequency reference). This key can be enabled or disabled with a
parameter setting (o2-02).
Displays each mode.
Returns to the status before the Enter Key is pressed.
Enables JOG operation when the 3G3FV is in operation with the

Digital Operator.

Selects the rotation direction of the motor when the 3G3FV is in
operation with the Digital Operator.
Selects digits for parameter settings. Also acts as the reset key when
an fault has occurred. (see note)
Selects modes, groups, functions, parameter names, and set values.
This key increases numbers when pressed.
Selects modes, groups, functions, parameter names, and set values.
This key decreases numbers when pressed.
Enters modes, functions, parameters, and set values after they are
set.
Starts the 3G3FV running when the 3G3FV is in operation with the
Digital Operator.
Stops the 3G3FV running. This key can be enabled or disabled with a
parameter setting (o2-02) in operation with the control circuit terminal.
Lit when in operation mode.
Lit when there is a forward command input.
Lit when there is a reverse command input.
Lit when the forward/reverse command from
the control circuit terminal is enabled.
Lit when the frequency reference from
control circuit terminals 13 and 14 is enabled.
Data Display
Keys
Function
Chapter 1