Omron SYSDRIVE 3G3FV User Manual page 267

Advanced Operation
Zero-servo End (Setting: 33)
OFF The zero-servo command isn't being input or zero-servo position control hasn't been completed.
ON The position has been brought within the zero servo completion width (b9-02) after the zero servo
command was input.
This output function indicates that zero-servo position control has been completed.
The output is turned ON after the zero servo command is input and the difference between the zero-
servo operation starting position and the current position is within the zero servo completion width
(b9-02).
H Multi-function Analog Input/Frequency Reference (Current)
(H3-05/H3-09)
Parameter Settings
Parameter Display name p y
number
H3-05 Terminal 16 Sel
H3-09 Terminal 14 Sel
Note These parameters cannot be changed during operation.
Setting g Function
0 Auxiliary reference (H3-05)
1 Frequency Gain
2 Frequency Bias
4 Voltage Bias
5 Accel/Decel Change
6 DC Brake Current
7 Overtorque Level
8 Stall Prevention Level
9 Reference Lower Limit
A Jump Frequency
B PID Feedback
C PID target value
D Frequency bias 2
10 Forward Torque Limit
11 Reverse Torque Limit
12 Regenerative Torque Limit
13 Torque reference
14 Torque Compensation Bias
15 Speed Limit
Setting g Units Default
range setting
0 to 1F --- 1F
1 to 1F --- 1F
Equivalent of 100% Input q
(10 V or 20 mA) (10 V
Maximum frequency
Frequency ref. of terminal 13
Maximum frequency
(added to H3-03)
Rated voltage (E1-05)
Accel/Decel times (C1-
Inverter's rated output current
Rated torque or Inverter's
rated output
(Setting in L6-05 is ignored.)
Inverter's rated output current
Maximum frequency
Maximum frequency
Maximum frequency
Maximum frequency
Maximum frequency (added
to H3-03 set value)
Rated torque
Rated torque
Rated torque
Rated torque
Rated torque
Rated torque
Valid access levels
V/f V/f with
Control PG
Basic or Advanced
Advanced
p
20 A)
V/f V/f
w/PG
OK OK
OK OK
OK OK
OK OK
) OK OK
OK OK
OK OK
OK OK
OK OK
OK OK
OK OK
OK OK
OK OK
--- ---
--- ---
--- ---
--- ---
--- ---
--- ---
Chapter 6
Open Loop Flux
Vector Vector
Control mode
Open-loop Flux
Vector Vector
OK OK
OK OK
OK OK
OK OK
OK ---
OK OK
--- ---
OK OK
OK OK
OK OK
OK OK
OK OK
OK OK
OK OK
OK OK
OK OK
--- OK
--- OK
OK OK
6-93