Omron SYSDRIVE 3G3FV User Manual page 86

Preparing for Operation
The following diagram shows this procedure in flowchart format.
S Setting Parameters in Each Access Level
The displays in program mode differ for each access level. (There is no difference in other modes.)
This section provides the procedure to change the acceleration time to 20 s in each access level. The
acceleration time (C1-01) is a parameter in program mode.
If the new parameter setting is not written to the Unit (by pressing the Enter Key) within one minute
after starting the procedure, the display will automatically revert to the original parameter setting. In
this case, the procedure must be started again.
3-6
Chapter 3