Omron SYSDRIVE 3G3FV User Manual page 106

Preparing for Operation
Group Group Function Function
Terminal e a H1 Digital Inputs
H2 Digital Outputs
H3 Analog Inputs
H4 Analog Outputs
H5 Serial Com Setup
Protection o ec o
L1 Motor Overload
L2 PwrLoss Ridethru
L3 Stall Prevention
L4 Ref Detection
L5 Fault Restart
L6 Torque Detection
L7 Torque Limit
L8 Hdwe Protection
Operator O e a o
o1 Monitor Select
o2 Key Selections
S Setting Parameters in Program Mode
The parameters that can be displayed and changed will vary depending on the access level that has
been set.
In the Quick-start level, the first parameter (b1-01) will be displayed when the Enter Key is pressed at the
program mode display. In the Basic level, the first function (b1) will be displayed when the Enter Key is
pressed at the program mode display. In the Advanced level, the first group (b) will be displayed when
the Enter Key is pressed at the program mode display.
For setting examples, refer to Setting Parameters in Each Access Level on page 3-6.
3-26
Comments Comments
Function selection for multi-function inputs
Function selection for multi-function outputs
Function selection for analog inputs
Function selection for analog outputs
Not Used. (Do not change these settings.)
Overload protection settings and selection
Selects the power-loss processing method.
Stall prevention settings and selection
Frequency detection settings and selection
Fault restart function settings
Overtorque detection settings and selection
Torque limit settings (vector control only)
Overheating and phase loss protection settings
Selects the display and setting methods.
Key function selection and other parameters
Chapter 3
Control mode
V/f V/f Open-loop
w/PG Vector
OK OK OK
OK OK OK
OK OK OK
OK OK OK
--- --- ---
OK OK OK
OK OK OK
OK OK OK
OK OK OK
OK OK OK
OK OK OK
--- --- OK
OK OK OK
OK OK OK
OK OK OK
Flux
Vector
OK
OK
OK
OK
---
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK