Installation
H Wiring a PG Speed Control Card
3G3FV-PPGA2 (For V/f With PG Feedback Mode Only)
Three-phase,
200 VAC (400 VAC)
Three-phase,
200 VAC (400 VAC)
Note 1. Twisted-pair shielded wire must be used for signal lines.
Note 2. Do not use the pulse generator's power supply for anything other than the pulse generator
(encoder). Using it for another purpose can cause malfunctions due to noise.
Note 3. The length of the pulse generator's wiring must not be more than 30 meters.
3G3FV
L1
T1
L2
T2
L3
T3
3G3FV
L1
T1
L2
T2
L3
T3
E6B2-CWZ3E Encoder
+12-V power supply
0-V power supply
12-V voltage output
(A/B phase)
Pulse 0 V
Pulse monitor output
E6B2-CWZ3C Encoder
+12-V power supply
0-V power supply
Open collector output
(A/B phase)
Pulse 0 V
Pulse monitor output
Chapter 2
2-43