Table of Contents
Advertisement
308 Advanced configuration
Configuring advanced parameters
Configuring advanced parameters
On Devices, click Configuration > Node > Network Security
■
Parameters and choose a node from the pull-down list in Select Node.
Click OK.
2
In Symantec Network Security Configuration Parameters, under Log and
Database Parameters, set values for each of the listed parameters.
3
In Size to Trigger Rotation, enter the rotation size.
4
In Flag for SCP Usage, click True.
5
In Destination Host for SCP, type the target host name or IP address.
6
In User Account for SCP, type user name to transfer files to on the target
host.
7
In Destination Directory for SCP, type the directory to transfer files to on
the target host.
8
In Limit Size for Archive Directory, type the maximum disk space allowed
for archived files.
9
In Limit Size for Traffic Record Directory, type the maximum disk space
allowed for traffic record data.
10 Click Apply.
The Symantec Network Security software and the Symantec Network Security
7100 Series appliance employ a common core architecture that provides
detection, analysis, storage, and response functionality. Most procedures in this
section apply to both the 7100 Series appliance and the Symantec Network
Security 4.0 software. The 7100 Series appliance also provides additional
functionality that is unique to an appliance. Each section describes this
additional functionality in detail.
A variety of configurable parameters enable you to customize your Symantec
Network Security intrusion detection system. Most parameters apply to both
Symantec Network Security and Symantec Network Security 7100 Series
systems, and to clusters, single nodes, and/or to sensors.
This section describes the following topics:
About parameters for clusters, nodes, and sensors
■
About basic setup and advanced tuning
■
Configuring node parameters
■
Configuring basic parameters
■
Advertisement
Table of Contents
