Symantec 10521146 - Network Security 7120 Administration Manual page 93

Note: The model number of a 7100 Series node cannot be edited. To change
it, you must delete the node object and add a new one using the desired
model number.
2
In Add 7100 Series Node or Edit 7100 Series Node, enter a descriptive name
of up to 40 characters for the device. This name appears in the topology tree.
See "Name" on page 77.
3
Enter an optional customer ID of up to 40 characters.
See "Customer IDs"
4 Enter the IP address for the node.
If the node is behind a NAT router, this IP address is the publicly visible
address.
Note: If you change the IP address of a node, a prompt requests you to edit
settings in the Advanced Network Options tab. Make sure the values in the
Netmask and Default Router fields are valid for the new IP address. See
"Viewing advanced network options"
5 Enter a unique node number between 2 and 120, inclusive, that is not
assigned to any other node in the cluster.
Note: Use this same number for the QSP Node Number during initial
configuration on the designated appliance.
See "Node number"
6 Click Monitoring Group and select a group from the pull-down list.
7 In Failover Group Information, do one of the following:
If you do not want to provide failover, proceed to the next step.
■
If you want to provide failover, click Failover Group Member, and
■
provide a Failover Group Number between 1 and 99, inclusive.
All nodes within the failover group must use the same group number.
See "Establishing high availability failover"
8 Do one of the following:
If adding a 7100 Series node in a cluster, in Master Node Sync
■
Information, enter the synchronization password.
Use the same passphrase for the Master Node Password during initial
configuration on the designated appliance.
See "Synchronization passphrases"
If editing a 7100 Series node, proceed to the next step.
■
on page 77.
on page 94.
on page 77.
on page 78.
Populating the topology database
Adding nodes and objects
on page 287.
93