Symantec 10521146 - Network Security 7120 Administration Manual page 263

does not affect the local UNIX system
the Network Security syslog module is disabled.
To configure this parameter
1 Click Configuration > Node > Network Security Parameters.
2 In Select Node, choose the node from the pull-down list, and click OK.
3 In the left pane, under Log & Database Parameters, click this parameter to
display it.
4 In the lower right pane, enter a value.
5 Click Apply.
6 In Apply Changes To, select the node to which to apply the parameter.
7 Click OK to save the changes to this node and close.
Caution: Make sure that sufficient RAM exists on the system for this parameter.
It may take up to 10 minutes for changes to this parameter to take effect.
Setting Remote Syslog Destination Port
Remote Syslog Destination Port indicates the remote syslog port that Symantec
Network Security uses.
The default value is the standard syslog port (514), if not set otherwise. This
value does not affect the local UNIX system
To configure this parameter
1 Click Configuration > Node > Network Security Parameters.
2 In Select Node, choose the node from the pull-down list, and click OK.
3 In the left pane, under Log & Database Parameters, click this parameter to
display it.
4 In the lower right pane, enter a value.
5 Click Apply.
6 In Apply Changes To, select the node to which to apply the parameter.
7 Click OK to save the changes to this node and close.
in any way. If this value is not set,
syslogd
in any way.
syslogd
Managing log files 263
Exporting data