Using The Lcd Panel - Symantec 10521146 - Network Security 7120 Administration Manual

Using the LCD panel

appliance from the serial console. Rebooting includes the entire system and is
rarely necessary except during installation and changes to the IP address.
To reboot an appliance node from the serial console
1 Connect your laptop or other serial device to the appliance with the serial
console cable.
2
Using a serial terminal application, login to the appliance as
3 Type the command:
reboot
Stopping via the serial console
You must have secadm access to stop Symantec Network Security on the
appliance from the serial console.
To stop Symantec Network Security from the serial console
1 Connect your laptop or other serial device to the appliance with the serial
console cable.
2 Using a serial terminal application, login to the appliance as
3 Type the command:
stop
Shutting down via the serial console
You must have secadm access to shut down the appliance from the serial
console.
To shut down an appliance from the serial console
1 Connect your laptop or other serial device to the appliance with the serial
console cable.
2 Using a serial terminal application, login to the appliance as
3 Type the command:
shutdown
In addition to the Network Security console, Symantec Network Security 7100
Series appliances also provide a management interface called the LCD panel.
You can use the LCD panel on an appliance to perform some basic initial
Getting started
About the management interfaces
secadm
secadm
secadm
51
.
.
.