Symantec 10521146 - Network Security 7120 Administration Manual page 203

Device Name
■
Location
■
State
■
Marked
■
Node #
■
Node Name
■
Other Node
■
#'s
Note: All users can select incident columns. See
page 319 for more about permissions.
See the following for related information:
See "About incident/event reports"
■
See "Sorting column data"
■
Selecting event columns
Not all events contain data in every category, so you may want to remove empty
or irrelevant columns, or add others to customize the display. All users can
modify the display of event information by selecting columns.
To select event columns
1 In the Incidents tab, in the lower Events at Selected Incidents pane, click
Columns.
2 In Table Column Chooser, do one of the following:
Click Select All to select all columns.
■
Click the individual columns you want to view.
■
3 Click OK to save and close.
Indicates the name of the device where the incident was
detected.
Indicates the location of the device where the incident was
detected.
Indicates the condition of the incident, either
. Incidents to which no new events have been added for a
Closed
given amount of time are considered idle, and Symantec
Network Security closes them.
Indicates whether you marked the incident as viewed.
Indicates the number of the software or appliance node that
detected the incident.
Indicates the name of the software or appliance node that
detected the incident.
Indicates the numbers of the software or appliance node that the
incident was cross-node correlated to, if any.
on page 229.
on page 192.
Monitoring
Managing incident and event data
Active
"User groups reference"
203
or
on