Monitoring flow statistics
Enabling flow data collection
2
In Select Node, choose the node from the pull-down list, and click OK.
3
In the left pane, click Event Correlation 'Destination Port' Weight.
4
In the lower right pane, enter a value between 0 and 10.
5
Click Apply.
6
In Apply Changes To, select the node to which to apply the parameter.
7
Click OK to save the changes to this node and close.
This section describes the following topics:
Enabling flow data collection
■
Configuring FlowChaser
■
Symantec Network Security can receive flow data from its own sensors, routers,
and from third-party sensors. You can optimize this by enabling FlowChaser, a
flow data store that provides data source for Symantec Network Security to
analyze and correlate. FlowChaser receives information about network flows
from Network Security sensors, routers, and third-party devices. FlowChaser
stores the data in an optimized fashion that Symantec Network Security uses for
TrackBack and response actions.
To enable flow data collection
1
In the Network Security console, click the Devices tab.
2
In the topology tree, right-click a monitoring interface.
3
In the pop-up list, click Configure Sensor Parameters.
4
In the left pane of Sensor Configuration Parameters, click Enable Flow
Statistics Collection.
5
In the right pane, click True.
6
Click Apply.
7
In Apply Changes To, select a monitoring interface and click OK.
Monitoring
Monitoring flow statistics
219