Symantec 10521146 - Network Security 7120 Administration Manual page 146

146 Responding
Setting response actions
Maximum number of SNMP notifications: Enter the number of
■
notifications you want to send.
Delay between SNMP notifications (mins): Enter the time in minutes
■
that you want Symantec Network Security to wait before sending
another notification.
5 In Configure Response Action, click OK to save and exit.
6 In Response Rules, click OK to save and exit.
Setting SNMP notification parameters
The Network Security console provides a way to refine the SNMP notification
response action by tuning the following configurable parameters:
SNMP Manager
■
SNMP Community String
■
SNMP Manager
SNMP Manager indicates where the software or appliance node sends SNMP
traps.
To configure this parameter
1 Click Configuration > Node > Network Security Parameters.
2
In Select Node, choose the node from the pull-down list, and click OK.
3
In the left pane, click SNMP Manager.
4 In the lower right pane, enter the SNMP Manager that will receive SNMP
traps from the node.
5 Click Apply.
6 In Apply Changes To, select the node to which to apply the parameter.
7 Click OK to save the changes to this node and close.
SNMP Community String
SNMP Community String indicates the community string that Symantec
Network Security uses to send traps to the SNMP Manager.
To configure this parameter
1 Click Configuration > Node > Network Security Parameters.
2
In Select Node, choose the node from the pull-down list, and click OK.
3 In the left pane, click SNMP Community String.