Symantec 10521146 - Network Security 7120 Administration Manual page 91

Caution: Click Topology > Save Changes before quitting the Network
Security console. You will lose any unsaved changes when you exit.
See "Deleting objects"
About the Networks tab
The Networks tab lists the networks that this interface monitors. Replace the
default entry with valid monitored networks before starting a sensor on the
interface.
To add or edit monitored networks
1 On the Networks tab, do one of the following:
Click Add.
■
Select a monitored network, and click Edit.
■
2
Replace the default 0.0.0.0/0 with all valid network IP addresses monitored
by this interface, in CIDR format.
3 Click OK.
Caution: You must replace the default entry (0.0.0.0/0) in the Networks tab
with valid monitored networks in CIDR format before starting a sensor. If
you fail to take this step, the database can fill with invalid data and result in
a loss of detection and alerting functionality.
on page 81.
Populating the topology database
Adding nodes and objects
91