Table of Contents
Advertisement
116 Protection policies
Using protection policies
Undoing policy settings
by configuring a protection policy with blocking enabled. You can enable
blocking only on in-line interface pairs on a 7100 Series node.
To make sure that blocking is enabled at the event list level, see also
or disabling blocking rules"
To enable or disable blocking on in-line interfaces
1
In the Policies > Protection Policies tab, in the right pane, click an in-line
pair.
2
Do one of the following:
Click Enable Blocking.
■
Click Disable Blocking.
■
3
Click Apply to save and apply changes.
This section describes how to remove or revert the application of policies to
interfaces.
Unapplying protection policies
The Network Security console provides a way to unapply or remove the
application of protection policies from node interfaces.
To unapply a protection policy assignment
1
In the Policies tab, in the right Policies Applied To Interfaces pane,
right-click an interface.
2
Click Unapply Policy from the pop-up list.
3
In the Protection Policies tab, click Apply to save and apply changes.
Removing policies set to interfaces
The Network Security console provides an alternative to unapplying protection
policies from interfaces.
To remove policies from interfaces
1
In the Policies tab, click a protection policy in the left pane.
2
Click Set to Interfaces.
3
In Apply Policy to Selected Interface, click the interface or group of
interfaces to remove this policy from, and click OK.
on page 123.
"Enabling
Advertisement
Table of Contents
