Table of Contents
Advertisement
282 Advanced configuration
Integrating third-party events
Backup up cluster-wide data
Integrating third-party events
To configure this parameter
1
Click Configuration > Node > Network Security Parameters.
2
In Select Node, choose the node from the pull-down list, and click OK.
3
In the left pane, click SESA.
4
In the lower right pane, do one of the following:
Click True to enable the SESA Bridge.
■
Click False to disable the SESA Bridge.
■
5
Click Apply.
6
In Apply Changes To, select the node to which to apply the parameter.
7
Click OK to save the changes to this node and close.
Caution: If you change the QSP port number, restart all nodes in the cluster
before logging in with the new number.
You can backup data from one node and exchange between nodes in the cluster
to a certain degree.
See
"Backing up and restoring"
Note: SuperUsers can back up node configurations; Administrators,
StandardUsers, and RestrictedUsers cannot. See
page 319 for more about permissions.
Symantec Network Security can be configured to receive events from
third-party devices including ManTrap 2.1 and later, and Symantec Decoy
Server 3.1, as well as from other third-party security sensors. Symantec
Network Security can be configured to aggregate and correlate those events
with all other events that Symantec Network Security detects. Other third-party
sensors require separate Smart Agent software.
This section describes the following topics:
Integrating via Smart Agents
■
Integrating with Symantec Decoy Server
■
on page 297.
"User groups reference"
on
Advertisement
Table of Contents
