Table of Contents
Advertisement
156 Responding
Managing flow alert rules
Editing flow alert rules
Deleting flow alert rules
8
In Flow Alert Rules, click OK to save and exit.
The Network Security console provides a way to rearrange the sequence of flow
alert rules.
To rearrange the order of flow alert rules
1
In the Network Security console, click Configuration > Flow Alert Rules.
2
In Flow Alert Rules, select an existing flow alert rule and click Edit.
3
In Flow Alert Rule, in Rule Type, do one of the following:
Click Permit.
■
Click Alert.
■
See
"Using the permit rule type"
4
Click Set Interfaces.
5
In Select Interface or Device, select the object where you want the rule
applied, and click OK.
6
In Flow Alert Rule, select the following information from the pull-down
lists, and click Add:
Source IP address, mask, and port
■
Destination IP address, mask, and port
■
See
"Providing an appropriate mask"
7
In Flow Alert Rule, click OK.
8
In Flow Alert Rules, do one of the following:
Click Move Up.
■
Click Move Down.
■
The flow alert rules are applied in sequential order from the top of the list to
the bottom. Moving a rule up or down shifts it in relation to the other rules,
and determines when it will be applied in the sequence.
9
Click OK to save and exit.
The Network Security console provides a way to delete unnecessary flow alert
rules easily.
To add or edit a flow alert rule
1
In the Network Security console, click Configuration > Flow Alert Rules.
on page 157.
on page 157.
Advertisement
Table of Contents
