222 Monitoring
Monitoring flow statistics
Setting FlowChaser Sensor Threads
FlowChaser Sensor Threads determines how many threads for each sensor to
receive flow data. In general, this should be set to 1 less than the number of
processors on the software or appliance node, with a minimum value of 1. The
default value is 2.
To configure this parameter
1
Click Configuration > Node > Network Security Parameters.
2
In Select Node, choose the node from the pull-down list, and click OK.
3
In the left pane, click FlowChaser Sensor Threads.
4
In the lower right pane, enter a value.
5
Click Apply.
6
In Apply Changes To, select the node to which to apply the parameter.
7
Click OK to save the changes to this node and close.
Note: Restart Symantec Network Security for changes to this parameter to take
effect.