Table of Contents
Advertisement
272 Advanced configuration
Updating Symantec Network Security
Setting the LiveUpdate server
2
In the left pane, select the nodes to receive updates.
3
On the LiveUpdate tab, click Scan For Updates.
4
In the right pane, do one of the following:
Click Select All to select the entire list.
■
Click Clear All to deselect the entire list.
■
Click each update to select it individually.
■
5
Click Apply Updates to activate the selection.
Note: SuperUsers and Administrators can apply updates using the Network
Security console; StandardUsers and RestrictedUsers cannot. See
reference"
on page 319 for more about permissions.
The Network Security console provides a way to establish a LiveUpdate server.
To set the LiveUpdate server
1
In the Network Security console, click Admin > LiveUpdate.
2
On the LiveUpdate tab, click Set LiveUpdate Server.
3
In LiveUpdate Server Configuration, provide the following information:
Enter the Hostname or IP address of the LiveUpdate server.
■
Select the Type from the pull-down list.
■
If you selected the FTP type, enter the Username and Password.
■
Click OK.
■
Note: SuperUsers and Administrators can establish a LiveUpdate server using
the Network Security console; StandardUsers and RestrictedUsers cannot. See
"User groups reference"
Note: When you add them to an established cluster using an alternative
LiveUpdate server, set the LiveUpdate server for each new node. New nodes do
not automatically use the LiveUpdate server of the cluster, until you set an
alternative LiveUpdate server.
on page 319 for more about permissions.
"User groups
Advertisement
Table of Contents
