50 Getting started
About the management interfaces
configure
■
start
■
restart
■
stop
■
unconfigure
■
install-bridge
■
uninstall-bridge
■
date
■
elevate
■
passwd
■
reboot
■
shutdown
■
This section describes the following subset of procedures available on the serial
console:
Restarting via the serial console
■
Rebooting nodes via the serial console
■
Stopping via the serial console
■
Shutting down via the serial console
■
See the Symantec Network Security 7100 Series Implementation Guide for the
full range of procedures available on the serial console.
Restarting via the serial console
The Symantec Network Security 7100 Series provides a way to restart appliance
nodes using the serial console. You must have secadm access to restart
Symantec Network Security on the serial console. Restarting includes the
Symantec Network Security software and enables you to address an intermittent
problem.
To restart Symantec Network Security from the serial console
1
Connect your laptop or other serial device to the appliance with the serial
console cable.
2
Using a serial terminal application, login to the appliance as
3
Type the command:
restart
Rebooting nodes via the serial console
The Symantec Network Security 7100 Series provides a way to reboot appliance
nodes using the serial console. You must have secadm access to reboot the
.
secadm