Symantec 10521146 - Network Security 7120 Administration Manual page 267

3 In the left pane, under Log & Database Parameters, click this parameter to
display it.
4 In the lower right pane, enter a path to the destination directory on the
remote host in which to place the logs. The user specified in the User
Account for SCP parameter must have write permission to this directory.
5 Click Apply.
6 In Apply Changes To, select the node to which to apply the parameter.
7 Click OK to save the changes to this node and close.
Setting Location of SCP Binary
Location of SCP Binary indicates the path to the SCP binary on the Network
Security software node. By default, the binary is in the
directory. Set the value for this parameter if the SCP binary is in an alternative
location.
Note: You do not need to set Location of SCP Binary for 7100 Series nodes,
because the location of the SCP binary is predetermined on appliances.
To configure this parameter
1 Click Configuration > Node > Network Security Parameters.
2 In Select Node, choose the node from the pull-down list, and click OK.
3 In the left pane, under Log & Database Parameters, click this parameter to
display it.
4 In the lower right pane, enter the path to the SCP binary on the Network
Security software node if it differs from the default.
5 Click Apply.
6 In Apply Changes To, select the node to which to apply the parameter.
7 Click OK to save the changes to this node and close.
Note: For how to verify remote log archiving manually, see
Knowledge Base" on page 22.
Managing log files
Exporting data
/usr/local/bin/scp
"About the
267