Symantec 10521146 - Network Security 7120 Administration Manual page 144

144 Responding
Setting response actions
Setting Subject Line
Subject Line indicates the subject line used when Symantec Network Security
sends automatic email notifications. The default value is
.
Security Alert
You can use response variables to set the subject line. For example, to set the
Subject Line to display Date, Time, Source, Destination, and Event,
enter in the lower right pane. Optionally, you can separate the
%T %s %d %t
variables by a space to expedite possible future editing. Upon execution, the
values from the corresponding event replace the variable. You can also specify
the subject line with Configure Response Action using these same variables.
To configure this parameter
1 Click Configuration > Node > Network Security Parameters.
2 In Select Node, choose the node from the pull-down list, and click OK.
3 In the left pane, click Subject Line.
4 In the lower right pane, enter an alternative subject line.
5 Click Apply.
6 In Apply Changes To, select the node to which to apply the parameter.
7 Click OK to save the changes to this node and close.
See "Table of response variables"
Setting SMTP Server
SMTP Server indicates the SMTP mail server that Symantec Network Security
uses to send email notifications. The default value is
To configure this parameter
1 Click Configuration > Node > Network Security Parameters.
2 In Select Node, choose the node from the pull-down list, and click OK.
3 In the left pane, click SMTP Server.
4 In the lower right pane, enter an alternative mail server.
5 Click Apply.
6 In Apply Changes To, select the node to which to apply the parameter.
7 Click OK to save the changes to this node and close.
on page 148.
mail
Symantec Network
.