Symantec 10521146 - Network Security 7120 Administration Manual page 99

Right-click an existing interface group object, and click Edit on the
■
pop-up menu.
2 In Add Interface Group or Edit Interface Group, enter a descriptive name.
See "Name" on page 77.
3
In Expected Throughput, click the expected throughput on the pull-down
list.
4 In TCP Reset Interface, click the reset interface on the pull-down list.
The reset interface must be cabled to access the monitored network. See the
Symantec Network Security 7100 Series Implementation Guide.
5 In Description, enter an optional description of up to 255 characters.
See "Description"
6 On the Networks tab, click Add, enter the network IP address of all
networks monitored by this interface group using CIDR format, and click
OK.
Caution: You must replace the default entry (0.0.0.0/0) in the Networks tab
with valid monitored networks in CIDR format before starting a sensor on
the interface. If you fail to take this step, the database can fill with invalid
data and result in a loss of detection and alerting functionality.
7 On the Interfaces tab, press Ctrl and click to select multiple interfaces for
the interface group, and click OK.
Note: Click Topology > Save Changes before quitting the Network Security
console. You will lose any unsaved changes when you exit.
See "Deleting objects"
on page 77.
on page 81.
Populating the topology database
Adding nodes and objects
99