Table of Contents
Advertisement
310 Advanced configuration
Configuring advanced parameters
Configuring node parameters
Configuring basic parameters
Note: SuperUsers and Administrators can view and edit the parameter
configurations. StandardUsers and RestrictedUsers can view them. See
groups reference"
on page 319 for more about permissions.
The Network Security console provides a way to manage single peer nodes by
configuring node parameters.
To configure node parameters
1
Click Configuration > Node > Network Security Parameters.
2
In Select Node, choose the node from the pull-down list, and click OK.
3
In the left pane, click the parameter that you want to configure.
4
In the lower right corner of the Configuration Parameters pane, click the
radio button or enter the value of the parameter.
5
Click Apply.
6
In Apply Changes To, select the node or subset of nodes that you want to
apply the parameter to.
7
Click OK to save the changes to this sensor and close.
Note: We recommend that you periodically back up the configuration database.
"Backing up Symantec Network Security configurations"
Note: SuperUsers can configure advanced cluster, node, and sensor parameters;
Administrators, StandardUsers, and RestrictedUsers cannot. See
reference"
on page 319 for more about permissions.
The Network Security console provides a way to configure basic automatic tasks
using the following parameters:
Configuring FlowChaser
■
Tuning incident parameters
■
Controlling user access
■
Setting a cluster-wide parameter
■
"User
on page 298.
"User groups
Advertisement
Table of Contents
