DigiDesign D-Control Manual page 77

Automation Mode Controls
The Automation Mode controls are used to display and set au-
tomation modes. These switches light to indicate that at least
one channel is in that automation mode. If multiple channels
are selected and set to different automation modes, all appli-
cable mode switches are lit.
These Automation Mode controls mirror the function of the
on-screen Automation Mode selector for each track, and let
you change automation modes during playback.
Automation Write
Mode switch
Automation Touch
Mode switch
Automation Latch
Mode switch
Automation Mode controls
To set the automation mode of one or more channels:
Hold an Automation Mode switch (Write, Touch, Latch,
1
Trim, Read, or Off).
Press the Select switches on the channels whose automation
2
mode you want to set.
To set the automation mode of one or more selected channels:
Press the Do To Selected switch.
1
Press the Select switches on the channels whose automation
2
mode you want to set.
Press an Automation Mode switch (Write, Touch, Latch,
3
Trim, Read, or Off).
To set the automation mode of all channels:
Press the Do To All switch.
1
Press an Automation Mode switch (Write, Touch, Latch,
2
Trim, Read, or Off).
Write Switch
The Write switch indicates or sets the automation mode for
the selected tracks to Write mode.
Touch Switch
The Touch switch indicates or sets the automation mode for
the selected tracks to Touch mode.
Latch Switch
The Latch switch indicates or sets the automation mode for
the selected tracks to Latch mode.
Trim Switch
The Trim switch indicates or sets the automation mode for the
selected tracks to Trim mode.
Read Switch
The Read switch indicates or sets the automation mode for the
selected tracks to Read mode.
Off Switch
The Off switch indicates or sets the automation mode for the
Automation Trim
selected tracks to Off.
Mode switch Mode switch
Automation Read
Talkback Switch
Mode switch
Two Talkback switches, located at the bottom of each Chan-
Automation Off
switch
nel Strip Master section on the Main Unit, provide mirrored
control of the D-Control Talkback function.
Talkback switch
The Talkback switches can follow momentary or latched be-
havior. If held, the switch is active only when pressed down.
If rapidly double-pressed, the switch latches on and flashes to
indicate that talkback is active. Press the switch again to turn
off talkback.
Talkback can be activated automatically. See "Auto Talkback
Switch" on page 123 for more information.
Talkback level is set with the Talkback controls in the Monitor
section. See "Talkback/Listen System" on page 122 for more
information.
Talkback switch
Chapter 6: Channel Strip Controls 69