DigiDesign D-Control Manual page 68

Assign Outputs Switch
The Outputs switch invokes Assign Outputs mode, in which
the bottom row of encoders shows channel outputs.
When assigning an output, the Select switch on the bottom
encoder is used to navigate down through Output menu lev-
els, and the encoder knob is used to scroll through available
choices at each level:
• Output type (Interface or Bus), shown in yellow
• Individual outputs, shown in green
Press the Bypass/Mute/Pre switch on the bottom encoder to
navigate back up the Output menu levels.
Assign Sends Switch
The Sends switch invokes Assign Sends mode, in which the
channel encoders shows the sends on a channel.
When assigning a send, the encoder Select switch is used to
navigate down through Send menu levels, and the encoder
knob is used to scroll through available choices at each level:
• Send type (Interface or Bus), shown in yellow
• Individual sends, shown in green
The Bypass/Mute/Pre switch on each encoder is used to navi-
gate back up the Send menu levels.
Assign Inserts Switch
The Inserts switch invokes Assign Inserts mode, in which the
channel encoders show the inserts on a channel. When as-
signing an insert, the encoder Select switch is used to navigate
down through Insert menu levels, and the encoder knob is
used to scroll through available choices. The Bypass/Mute/Pre
switch on the bottom encoder is used to navigate back up the
Insert menu levels.
The order in which plug-ins appear in the Insert menu is de-
termined by the Pro Tools Display preference for plug-in orga-
nization.
If the Organize Plug-in Menus by Category option is selected,
menu levels and choices include:
• Insert type (TDM plug-in, RTAS plug-in, Multi-Mono
TDM plug-in, Multi-Mono RTAS plug-in, or Hardware In-
sert), shown in yellow
• Plug-in subfolder (such as EQ, Dynamics, Pitch Shift, Re-
verb, and Delay), shown in yellow
• Individual insert or plug-in, shown in green
If the Organize Plug-in Menus by Category option is not se-
lected, the Plug-in subfolder level is not present.
60 D-Control Guide
To assign an input, output, send or insert:
Press an Assign switch to enter the corresponding Assign
1
mode.
On the channel where you want to make the assignment,
2
turn an encoder knob to select from the first level of menu
choices.
Press the encoder Select switch to move down and the By-
3
pass/Mute/Pre switch to move up through menu levels.
Do one of the following:
4
• Press the flashing encoder Select switch or press the flash-
ing Assign switch to confirm the assignment.
– or –
• Press the flashing Escape switch to cancel the assign-
ment.
To assign multiple inputs, outputs, sends, or inserts:
Press an Assign switch to enter the corresponding Assign
1
mode.
Turn the encoder knobs and use the encoder Select and By-
2
pass/Mute/Pre switches to select each assignment.
Do one of the following:
3
• Press the flashing Assign switch to confirm all the assign-
ments at once.
– or –
• Press the flashing Escape switch to cancel all the assign-
ments.
To remove an input, output, send or insert:
Press an Assign switch to enter the corresponding Assign
1
mode.
For the assignment you want to remove, press the encoder
2
Bypass/Mute/Pre switch repeatedly until you reach top level
menu for the assignment.
Turn the encoder knob counter-clockwise until no assign-
3
ment is visible.
Do one of the following:
4
• Press the flashing encoder Select switch or press the flash-
ing Assign switch to confirm the removal.
– or –
• Press the flashing Escape switch to cancel the removal
and restore the assignment.