DigiDesign D-Control Manual page 103

Audition Switches
The Audition switches are used to activate pre-roll and
post-roll in playback, define selection in and out points, and
trigger automatic playback of ranges.
Pre-Roll Mark Out
switch switch
Audition Mark In
switch switch
Audition switches
Audition Switch
The Audition switch toggles Audition mode on and off. When
Audition mode is on, this switch lights.
When Audition mode is on, you can quickly listen to either
the start or end of a selection, with or without pre-roll or
post-roll, by pressing the following switches:
Pre-Roll Switch Plays audio starting at the pre-roll point up to
the beginning of the selection.
Mark In Switch Plays audio starting at the selection start
through the length of the post-roll amount.
Mark Out Switch Plays audio back-timed from the selection
end by the pre-roll amount.
Post-Roll Switch Plays audio starting at the end of a selection
through the post-roll amount.
Pre-Roll and Post-Roll Switches
When Audition mode is off, the Pre-Roll and Post-Roll
switches toggle pre-roll and post-roll playback on and off in
Pro Tools. When pre-roll or post-roll is active, the correspond-
ing switch lights.
When Audition mode is on, the Pre-Roll and Post-Roll
switches play a range of audio around the current Edit selec-
tion.
Post-Roll
switch
Mark In and Mark Out Switches
When Audition mode is off, the Mark In and Mark Out
switches are used to define selection start and end during play-
back, or when using the Scrub/Shuttle wheel.
When Audition mode is on, the Mark In and Mark Out
switches play a range of audio around the current Edit selec-
tion.
To move the selection start:
With the transport stopped, hold the Mark In switch and turn
the Scrub/Shuttle wheel.
To move the selection end:
With the transport stopped, hold the Mark In switch and turn
the Scrub/Shuttle wheel.
To move the entire selection:
With the transport stopped, hold both the Mark In and Mark
Out switches and turn the Scrub/Shuttle wheel.
Locate Switches
The Locate switches move the Pro Tools transport to the des-
ignated location.
Go To Start Go To End Back Back and Play
switch switch switch
Locate switches
Go To Start Switch
The Go To Start switch returns the playback cursor to the be-
ginning of the session.
Go to End Switch
The Go To End switch moves the playback cursor to the end of
the session.
Back Switch
The Back switch moves the playback location backward by the
Back/Forward Amount.
To move the playback location forward:
Hold Alt (Windows) or Option (Mac) and press the Back
switch in the Transport section.
Chapter 8: Transport and Navigation Controls 95
Instant
Playback
switch
switch