DigiDesign D-Control Manual page 28

Using a 5/32-inch hex wrench, attach the crossbar to the
3
brackets with 1/4-inch-20 x 1/2-inch button head cap screws
(see Figure 9), using 6 screws on each side (3 in front and 3 in
back). Make sure to leave the screws loose enough so that the
legs can be moved side-to-side relative to the rear crossbar.
Figure 9. Attaching the crossbar
Locate the rear pan support rail, which is the larger of the
4
two rails provided with the stand.
Rear pan
support rail
Front pan
support rail
Figure 10. Side view of pan support rails
20 D-Control Guide
Position the rear rail so that the edge with the V-shaped
5
notch points toward the left stand leg.
Notch indicating left side of rear pan support rail
Figure 11. V-shaped notch in rear pan support rail
Lift the rear rail into place so that the rail rests on the rear
6
rail tabs of the stand legs (see Figure 12). The holes on the ends
of the rail should line up with the slots in the rear rail tabs on
each leg.
Figure 12. Rear support rail in place on left stand leg