DigiDesign D-Control Manual page 145

To name a snapshot:
In the Management section, press the Snap key repeatedly
1
until the desired snapshot preset number appears.
Double-press the Soft Key that corresponds to the snapshot
2
you want to name.
Type the name of the snapshot and press the Soft Key that
3
corresponds to Enter.
To recall a snapshot:
In the Management section, press the Snap key repeatedly
1
until the desired snapshot preset number appears. The bottom
four Soft Keys show four snapshot presets at a time (1–4, 5–8,
etc.).
Press the Soft Key that corresponds to the snapshot preset
2
you want to recall. The switch flashes to indicate that the pre-
set is loaded into the Capture buffer, and available to punch.
To clear a stored snapshot:
Hold Control+Alt+Start (Windows) or Command+Op-
tion+Control (Mac) and press the Soft Key that corresponds to
the snapshot you want to clear.
Punching Recalled Automation Values
To punch a recalled snapshot:
Move to a location where you want to apply the captured
1
automation states. You can do this during playback or while
the transport is stopped.
Press the Punch Capture switch in the Soft Keys section to
2
apply the captured automation states. The captured states are
applied to all automation types that are currently enabled in
the Automation window.
Joining Automation Values
To Join automation values:
Make sure the controls you want to join are in a write-en-
1
abled state.
Stop playback during an automation pass.
2
Start playback.
3
When you want to resume automation writing at the previ-
4
ous values, press the Join switch in the Automation area of the
Soft Keys section.
AutoMatching Automation Values
To AutoMatch all currently writing controls:
Make sure the automation types you want to AutoMatch are
1
write-enabled.
Start playback.
2
When you reach a point in the session where you want to re-
3
turn controls to their previously written values, press the Au-
toMatch switch in the Automation area of the Soft Keys
section.
AutoMatching Individual Controls
On D-Control, you can invoke AutoMatch on individual con-
trols or control types on single channels.
To AutoMatch all controls of a type on a channel:
Hold Control (Windows) or Command (Mac) and press any
of the following in the Channel Strip Mode controls for the
track whose controls you want to AutoMatch:
• Inserts
• Sends
• Pan
• Dyn
• EQ
To AutoMatch the volume fader on a channel:
Hold Control (Windows) or Command (Mac) and press the
Auto switch in the Channel Strip Function controls for the
channel.
To AutoMatch a pan control or the controls for an individual
insert or send on a channel:
Press the switch in the Channel Strip Mode controls to dis-
1
play the Pan controls or the top level of Inserts or Sends for the
channel.
Hold Control (Windows) or Command (Mac) and press the
2
Rotary Encoder Select switch for the control you want to Au-
toMatch:
• For Sends, the Send level, pan, and mute will AutoMatch.
• For Inserts, all automated controls will AutoMatch.
• For Pan, all pan sliders on the channel will AutoMatch.
To AutoMatch all controls for a plug-in displayed in the Dynamics
or EQ section:
Hold Control (Windows) or Command (Mac) and press the
Auto switch in the Dyn or EQ section of the console.
Chapter 11: Normal Mode Operations and Commands 137