DigiDesign D-Control Manual page 84

To change parameter mapping in a plug-in map:
Make sure the LrnTch (Learn Touch) preference (in the Op-
1
eration Soft Keys) is set to On.
Open the plug-in whose mapping you want to change.
2
Choose the map you want to change from the Map Preset
3
pop-up menu.
Put the plug-in into Learn mode. The plug-in map is focused
4
on the control surface.
On the control surface, do one of the following:
5
• For an EQ or Dynamics plug-in, make sure a plug-in of
the same type is displayed in the EQ or Dynamics section
of the control surface.
– or –
• For all other plug-in types, display a different instance of
the same plug-in type in a second location (for example,
on a channel strip in Normal mode, or in another bank of
Custom Faders).
Touch the encoder or press the switch for the parameter you
6
want to map. The encoder's auto LED or the switch's Mute
LED lights.
Locate the encoder where you want to change the mapping,
7
and if necessary, press the encoder Select switch to toggle be-
tween the two available views on the control.
Touch the encoder or press the B/M/P switch to map the pa-
8
rameter.
Take the plug-in out of Learn mode.
9
To remove parameter mapping from a plug-in map:
Make sure the LrnTch (Learn Touch) preference (in the Op-
1
eration Soft Keys) is set to On.
Open the plug-in whose mapping you want to change.
2
Choose the map you want to change from the Map Preset
3
pop-up menu.
Put the plug-in into Learn mode. The plug-in map is focused
4
on the control surface.
Locate the encoder where you want to change the mapping,
5
and if necessary, press the encoder Select switch to toggle be-
tween the two available views on the control.
Do one of following for each parameter mapping you want
6
to remove:
• If the Parameter menu shows No Control, touch the en-
coder or press the B/M/P switch to remove the parameter
mapping.
– or –
• If the Parameter menu shows the name of a preset, hold
Control (Windows) or Command (Mac) and press the
B/M/P switch to remove the parameter mapping.
Take the plug-in out of Learn mode.
7
76 D-Control Guide
Changing Plug-in Map Presets
You can select the next or previous plug-in map for a plug-in
directly from D-Control.
To enable the next or previous plug-in map from a channel strip:
Focus the plug-in in the channel strip so its controls are vis-
1
ible on the channel strip encoders.
Hold Start (Windows) or Control (Mac) and press the Page
2
Up (Next) or Page Down (Previous) switch in that channel
strip's Channel Strip Mode controls. The name of the plug-in
map preset is shown momentarily in the bottom encoder dis-
play.
To enable the next or previous plug-in map from the Custom
Faders:
Focus the plug-in in the Custom Faders section.
1
Hold Start (Windows) or Control (Mac) and press the Page
2
Up (Next) or Page Down (Previous) switch in a Custom Fader
channel. The name of the plug-in map preset is shown mo-
mentarily in the Custom Fader channel displays.
To select the next or previous plug-in map on multiple
channels, use the Do To All and Do To Selected switches
on D-Control.