Talkback/Listen System - DigiDesign D-Control Manual

Cue Input Source Selectors
Assign Talkback switch
Cue Input Source
switches
Cue Input Source selectors
Cue Input Source Switches
The Headphone/Cue monitor system has four input sources:
• Cue 1 Input (2 channels)
• Cue 2 Input (2 channels)
• Cue 3 Input (2 channels)
• Main Monitor Input (2 channels)
These input sources are routed to applicable outputs with the
Cue Input Source switches, which light when the correspond-
ing input source is active for a given output.
The table below shows possible outputs for each input source.
(Talkback can be added to each of the outputs.)
Input Possible Outputs
Cue 1 Cue 1, HP , Studio LS
Cue 2 Cue 2, HP , Studio LS
Cue 3 Cue 3, HP , Studio LS
Main Monitor Cue 1, Cue 2, Cue 3, HP , Studio LS
Assign Talkback Switch
The Assign Talkback switch lets you add the talkback signal to
any of the Headphone/Cue system outputs. The Assign Talk-
back switch lights to indicate that talkback is active for a given
output.
Headphone Outputs
A Headphone output is located on the underside of the
D-Control Main Unit, near the front right side. The other four
pairs of headphone outputs are available on the XMON inter-
face.
122 D-Control Guide

Talkback/Listen System

External Talkback
Level control
Built-in Talkback
Level control
Auto Talkback
switch
Talkback and Listen controls
The Talkback/Listen system has two talkback microphone in-
puts with independent level controls, and two Listen micro-
phone inputs with a shared level control.
Talkback Controls
The Talkback system has two talkback microphone inputs
(one external, one built-in) each with a touch-sensitive rotary
encoder for control of output volume. When either of these
encoders is touched, the monitor section display shows the
name of the input and its current volume level in dB. Level
control on each ranges from a minimum level of –INF to a
maximum level of +30 dB.
External Talkback Level Control
The External Talkback Level control adjusts the volume for
the external talkback microphone. When this encoder knob is
touched, the monitor section display shows "Ext TB" and the
level in dB.
Talkback Level Control
The Talkback Level control adjusts the volume of the built-in
(Internal) microphone, located on the meter bridge of the
D-Control Main Unit. When this encoder knob is touched,
the monitor section display shows "Int TB" and the level in
dB.
Listen Mic
Level control
Listen Mic
Select switches