Table of Contents
Advertisement
THROTTLE CABLE ADJUSTMENT/
THROTTLE LUBRICATION
3 - 10
EC35A001
THROTTLE CABLE ADJUSTMENT
1. Check:
Throttle grip free play a
Out of specification
Throttle grip free play a:
3 ~ 5 mm (0.12 ~ 0.20 in)
2. Adjust:
Throttle grip free play
Throttle grip free play adjustment steps:
Remove the throttle cable cover 1.
NOTE:
Before adjusting the throttle cable free
play, the engine idle speed should be
adjusted.
When the motorcycle is accelerating,
throttle cable #1 2 is pulled and throttle
cable #2 3 is pushed.
1st step:
Loosen the locknut 4 on throttle cable #2.
Turn the adjuster 5 in or out to take up
any slack on throttle cable #2.
2nd step:
Loosen the locknut 6 on throttle cable #1.
Turn the adjuster 7 in or out until the
specified free play is obtained.
Turning in:
Turning out:
Tighten the locknuts.
WARNING
After adjusting, turn the handlebar to
right and left and make sure that the
engine idling does not run faster.
Install the throttle cable cover.
EC35S002
THROTTLE LUBRICATION
1. Remove:
Rubber cover 1
Throttle cable cap 2
INSP
ADJ
Adjust.
Free play is increased.
Free play is
decreased.
Advertisement
Table of Contents
