Port Status and Configuration
Viewing Port Status and Configuring Port Parameters
Operating Notes:
■
■
Viewing Transceiver Status
The show tech transceivers command allows you to:
■
■
Figure 10-8 shows sample output from the show tech transceivers command.
ProCurve# show tech transceivers
Transceiver Technical Information:
The following transceivers may not function correctly:
Figure 10-8. Example of Show Tech Transceivers Command
10-14
For each port on the switch, the command provides a real-time display
of the rate at which data is received (Rx) and transmitted (Tx) in terms
of kilobits per second (KBits/s), number of packets per second (Pkts/
s), and utilization (Util) expressed as a percentage of the total band
width available.
The show interfaces <port-list> command can be used to display the
current link status and the port rate average over a 5 minute period.
Port rates are shown in bits per second (bps) for ports up to 1 Gigabit;
for 10 Gigabit ports, port rates are shown in kilobits per second
(Kbps).
Remotely identify transceiver type and revision number without having
to physically remove an installed transceiver from its slot.
Display real-time status information about all installed transceivers,
including non-operational transceivers.
Port # |
Type
-------+-----------+--------+------------------+----------
21
| 1000SX
22
| 1000LX
23
| ??
25
| 10GbE-CX4 | J8440A | US509RU079
26
| 10GbE-CX4 | J8440A | US540RU002
27
| 10GbE-LR
28
| 10GbE-SR
29
| 10GbE-ER
Port #
Message
--------
-------------------------------------
Port 23
Self test failure.
| Prod # | Serial #
| J4858B | CN605MP23K
| J4859C | H117E7X
| ??
| unsupported
| J8437B | PPA02-2904:0017
| J8436B | 01591602
| J8438A | PPA03-2905:0001
| Part #
|
| 2157-2345
|
|
|
| 2157-2345
| 2158-1000
|