Cli: Viewing And Configuring Sntp; Viewing The Current Sntp Configuration - HP ProCurve 6120G/XG Configuration Manual

CLI: Viewing and Configuring SNTP

CLI Commands Described in this Section
SNTP Command
show sntp
[no] timesync
sntp broadcast
sntp unicast
sntp server
Protocol Version
Priority
poll-interval
no sntp
This section describes how to use the CLI to view, enable, and configure SNTP
parameters.

Viewing the Current SNTP Configuration

Syntax: show sntp
This command lists both the time synchronization method
(TimeP, SNTP, or None) and the SNTP configuration, even if
SNTP is not the selected time protocol.
For example, if you configured the switch with SNTP as the time
synchronization method, then enabled SNTP in broadcast mode with the
default poll interval, show sntp lists the following:
SNTP: Viewing, Selecting, and Configuring
Page
9-9
9-11 and ff.,
9-16
9-12
9-12
9-12 and ff.
9-15
9-15
9-15
9-16
Time Protocols
9-9