Cli: Viewing And Configuring Sntp; Viewing The Current Sntp Configuration - HP 4108GL Management And Configuration Manual

Time Protocols
SNTP: Viewing, Selecting, and Configuring

CLI: Viewing and Configuring SNTP

CLI Commands Described in this Section
show sntp
[no] timesync
sntp broadcast
sntp unicast
sntp server
poll-interval
no sntp
This section describes how to use the CLI to view, enable, and configure SNTP
parameters.

Viewing the Current SNTP Configuration

This command lists both the time synchronization method (TimeP, SNTP, or
None) and the SNTP configuration, even if SNTP is not the selected time
protocol.
Syntax:
For example, if you configured the switch with SNTP as the time synchroni-
zation method, then enabled SNTP in broadcast mode with the default poll
interval,
Figure 8-5. Example of SNTP Configuration When SNTP Is the Selected Time
Synchronization Method
In the factory-default configuration (where TimeP is the selected time
synchronization method ),
though it is not currently in use. For example:
8-8
page 8
pages 9 and ff., 12
page 9
page 10
pages 10 and ff.
Protocol Version page 11
page 12
page 12
show sntp
lists the following:
show sntp
still lists the SNTP configuration even
show sntp