Table of Contents
Advertisement
Ethernet hub or switch should be ON.
Note:
If the Ethernet cable is not long enough to reach the
external hub/switch, purchase a longer straight-through
10Base-T Ethernet cable.
2.2.3 Connecting to an ISDN BRI Line (Vigor2200 and Vigor2200X
only)
A. S/T-Interface Model
1. Locate the ISDN cable (black color cable).
2. Plug one of the RJ-45 connectors on the cable into the ISDN
port on the rear panel of the router.
3. Plug the other end of the cable into any of the NT-1 (or NT1
plus) S/T-interface ports.
B. U-Interface Model
1. Locate the ISDN cable (black color cable).
2. Plug one of the RJ-45 connectors on the cable into the ISDN
port on the rear panel of the router.
3. Plug the other end of the cable into the ISDN wall outlet.
2.2.4 Connecting to a DSL/Cable Modem
The router supports connection of a DSL modem via an Ethernet inter-
face only. Non-Ethernet interface DSL modems, such as USB, ATMF-
25 are not supported.
1. Locate your Ethernet cable (should be provided by your ISP
or telcom).
Installation & Setup
2-5
Advertisement
Table of Contents
