Table of Contents
Advertisement
Getting Started
Vigor2200E:
LED Indicators
As shown above, there are 11 LEDs, reading from left to right, they
are ACT, four bandwidth utilization bar LEDs for the WAN port,
WAN, Broadband, P1, P2, P3 and P4. Most of the LEDs are the
same as those of the Vigor2200X, except for the additional Bandwidth
Utilization LEDs for the WAN port. The following describes only the
difference.
There are four LEDs below the bandwidth utilization bar. From left
to right they indicate bandwidth utilization, from low to high.
Rear Panel Description
The Vigor2200E has no ISDN port, the rest of the rear panel is the
same as that of the Vigor2200X.
1-11
Advertisement
Table of Contents
Need help?
Do you have a question about the Vigor2200 Series and is the answer not in the manual?