Table of Contents
Advertisement
Use Following Number to Callback & Callback Number:
Check here and enter a callback number for the router to call.
Callback Budget: Specifies a time budget for the callback
function. By default the value is zero, which means there is no
time limitation on call backs.
TCP/IP Network Settings
The following settings are required for proper LAN-to-LAN operation.
My WAN IP: In most cases you may accept the default value
0.0.0.0 in this field. The router will then get a WAN IP address
from the remote router during the IPCP negotiation phase. If
the WAN IP address is fixed by remote, specify the fixed IP
address here.
Remote Gateway IP: Specify the IP address of the remote
router.
Remote Network IP: Specify the network identification of the
remote network. For example, 192.168.1.0 is a network identi-
fication of a class-C subnet with netmask 255.255.255.0 (/24).
Remote Network Mask: Specify the netmask of the remote
network.
RIP Direction: The option specifies the direction of RIP (Rout-
ing Information Protocol) packets through the ISDN WAN con-
nection.
RIP Version: Selects the RIP protocol version. Specify Ver. 2
for greatest compatibility.
Exchange RIP Packets: The router has two local IP networks:
the1st subnet and 2nd subnet. Here you set which subnet will
exchange RIP packets with the remote network. Usually set to
"1st subnet" for routing between the 1st subnet and the remote
network.
Remote Access
4-15
Advertisement
Table of Contents
